made my own heat duct “reducer” today — for $25 in only two hours!

IMG_1392
custom heat duct reducer

 

Using a 24″ x 36″ sheet of (intended for ducting) sheet metal (~$10) and rivet tool + rivets (~$15) I was able to take a 14″ x 8″ opening and create a 4″ deep reducer down to a 14″ x 4″ opening.

This way, this can be an insert into an existing duct and “boot”/box that takes an 8″ pipe of heat into a 4″ deep 14″ x 8″ box.  It can then exhale the heat into a 14″ x 4” vent.

Why the insert you ask?  Hint: house was built in 1960.  Guess what the most common way to insulate ductwork *and* boxes/registers/boots was back then?   ASBESTOS, YAY!

So while we don’t know it is for sure, it sure looks like it (inspectors clued us in, t00).   So we not gonna mess w/ the box/ductwork that is in relatively good shape and not cut it, etc.

This is all part of a Bigger Project of redecoration we are doing at the bunny fort…

 

 

Published by

tracey pooh

i like digital video and road cycling

Leave a Reply

Your email address will not be published. Required fields are marked *